en operation
32
15.6 Starting the programme
▶ Press .
a The programme has ended when
the display shows "0:00".
Notes
¡ You can only change a pro-
gramme when running if you can-
cel it.
→"Terminate programme",
Page32
¡ The appliance switches off auto-
matically 1minute after the end of
the programme to save energy. If
you open the appliance door im-
mediately after the programme has
ended, the appliance will switch off
after 4 seconds.
15.7 Activating button lock
The button lock prevents the appli-
ance from being operated accident-
ally or incorrectly while running.
Requirement:A programme has
started. →Page32
▶ Press for approx. 3seconds.
a The button lock is activated and
will be automatically deactivated at
the end of the programme.
a The display shows "CL" when the
appliance is running.
a The button lock remains activated
with a power failure.
15.8 Deactivate button lock
▶ Press for approx. 3seconds.
15.9 Interrupting programme
Note:When you open the appliance
door once the appliance has heated
up, leave the door slightly ajar for a
few minutes and then close it. This
will help prevent excess pressure
building up in the appliance and stop
the appliance door bursting open.
1. Press .
a The programme is saved and the
appliance switches off.
2. Press to resume the pro-
gramme.
15.10 Terminate programme
To end a programme early or to
switch from a programme that has
already started, you will need to can-
cel it first.
▶ Press for approx.
3seconds.
a The programme is cancelled and
ends after approx. 1minute.
15.11 Switching off appliance
1. Please note the information on
Safe use →Page10.
2. Press .
3. To prevent damage from dripping
water, turn the water tap off tight
(not applicable to appliances with
Aqua-Stop).
Tip:If you press during the wash
cycle, the programme currently run-
ning will be interrupted. When you
switch the appliance back on, the
programme continues automatically.
To Next Page
Loading...
