Troubleshooting en
45
Fault Cause and troubleshooting
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
2. Do not place tableware or fragrance dispensers in
the tablet collecting tray.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food and do not
prerinse tableware.
Irreversible clouding
of glassware.
Glasses are not dishwasher-proof, only suitable for
dishwashers.
▶ Use dishwasher-proof glasses.
Glasses are usually only suitable for use in a dish-
washer, i.e. long-term wear or long-term changes
must be expected.
▶ Avoid a lengthy steam phase (standing time after
wash cycle ends).
▶ Use a programme with a lower temperature.
▶ Set the softening system to the water hardness.
▶ Use detergent with a glass protection component.
Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
▶ Use rust-resistant tableware.
Cutlery may also rust if washed together with rusting
items.
▶ Do not wash rusting items.
Salt content in washing water is too high.
1. Remove any spilled special salt from the tub.
2. Screw the cap of the special salt dispenser on tight.
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Spray arms were blocked by tableware so detergent
was not rinsed out.
▶ Check that the spray arms are not blocked and can
rotate freely.
Detergent dispenser was damp when detergent was
added.
▶ Only add detergent to a detergent dispenser when
dry.
Excessive formation of
foam occurs.
Hand washing-up liquid is present in dispenser for
rinse aid.
▶ Immediately add rinse aid to the dispenser.
→"Adding rinse aid", Page25
Rinse aid has been spilled.
To Next Page
Loading...
