en Fault, what to do?
22
Waste water pump
Large food remnants or foreign objects
which were not captured by the filters
may block the waste water pump. The
rinsing water will then be above
the filter.
m Warning – Risk of cuts!
When cleaning the waste water pump,
ensure that you do not injure yourself
on pieces of broken glass or pointed
implements.
In this case:
1. First disconnect the appliance from
the power supply.
2. Remove the filters 1*.
3. Scoop out water, use a sponge if
required.
4. Loosen screws on the pump cover
(Torx T 20) and pull off.
5. Check inner compartment
and remove any foreign objects.
6. Place pump cover in the original
position, press down and screw tight.
7. Install filters.
To Next Page
Loading...
