en Installation and connection
34
Fresh water connection
1. Connect the fresh-water connection
to the tap according
to the installation instructions with
the enclosed parts.
Ensure that the fresh-water
connection is not kinked,
crushed or twisted.
2. When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
Note printing on the water inlet hose!
If models are marked with 25°,
the water temperature may be max.
25 °C (cold water).
For all other models:
cold water preferred; hot water max.
temperature 60 °C.
Warm water connection
Warm water conne ction
* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e. g. solar heating system with
circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until ‘:‹‚ is indicated on the digital
display H.
5. Release button.
The factory-set value ‘:‹‹ is lit on
the digital display H.
To change the setting:
1. By rotating the programme
selector 8, you can switch the hot
water setting off ‘:‹‹ or on ‘:‹‚.
2. Press START button @.
The set value is saved.
To Next Page
Loading...
