en Getting to know your appliance
10
Selecting language
The language in the display window )2
can be set from p:‹‚, to p:ƒ„. German
p:‹‚ (Deutsch) is the factory setting.
* depending on model
To change the language:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
the digital display 8 •:‹... is
indicated.
4. Release both buttons.
5. Press programme button # until
the factory set value p:‹‚ is
indicated on the digital display 8.
“German” (Deutsch) is indicated in
the display window )2.
6. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of p:ƒ„ has been
reached, the display jumps back
to p:‹‚
7. Press START button )".
The set value is saved.
8. Close the door.
Display window
The display window )2 shows
the selected programme, the remaining
running time, the programme sequence
(in words and as a coloured progress
bar) and the selected options. In
addition, when there is low salt and/or
low rinse aid, the number of rinse cycles
still possible is indicated and the fault is
stated in the event of faults.
When the onboard computer
is switched on (see corresponding
chapter), further information is shown
and the water and energy consumption
is briefly displayed.
Language Setting
Deutsch p:‹‚
English p:‹ƒ
Français p:‹„
Nederlands p:‹…
Italiano p:ܠ
p:‹‡
Español p:‹ˆ
Português p:‹‰
Svenska p:‹Š
Norsk p:‚‹
Suomi p:‚‚
Dansk p:‚ƒ
Türkçe p:‚„
p:‚…
Polski p:‚†
Česky p:‚‡
Magyar p:‚ˆ
Hrvatski p:‚‰
Slovensko p:‚Š
Slovenský p:ƒ‹
p:ƒ‚
Română p:ƒƒ
q / Deutsch * p:
ƒ„
To Next Page
Loading...
Need help?
General
