en HomeConnect
36
Activating Remote Start
1. Press .
2. To open the appliance settings,
press for 3 seconds.
a flashes.
3. Press repeatedly until
flashes.
4. Press repeatedly until the
LEDs show the right value.
If LED A lights up, the function is
permanently deactivated.
If LED A and LED B light up, the
function can be selected using the
button.
If LED A, LED B and LED C light
up, the function is permanently ac-
tivated.
The factory setting is level 2 (LED
A and LED B).
5. To save the settings, press
for 3 seconds.
Restoring factory settings
1. Press .
2. To open the appliance settings,
press for 3 seconds.
a flashes.
3. Press repeatedly until ,
and flash.
4. Press to set the appliance
back to the factory settings.
a The appliance is reset.
HomeConnect
16 HomeConnect
HomeConnect
This appliance is network-capable.
Connect your appliance to a mobile
device to control its functions via the
HomeConnect app.
The HomeConnect services are not
available in every country. The avail-
ability of the HomeConnect function
depends on the availability of
HomeConnect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
Tip:Please also follow the instruc-
tions in the HomeConnect app.
Note:Please note the safety precau-
tions in this instruction manual and
make sure that they are also ob-
served when operating the appliance
via the HomeConnect app.
→"Safety", Page4
16.1 Setting up the
HomeConnect app
1. Install the HomeConnect app on
your mobile device.
2. Start the HomeConnect app and
set up access for HomeConnect.
The HomeConnect app guides
you through the entire login pro-
cess.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
To Next Page
Loading...
