Water softening system/Special salt en
9
+ Water softening
system/Special salt
Water softening system/Special salt
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
depositedontheutensils andinner
container.
Tap water above a specific
degree of water hardness must be
softened, i.e. descaled,
for use in a dishwasher. Water
is softened with special salt in the water
softening system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).
Setting
The amount of salt dispensed can be
set in 4 stages
depending on the hardness of your
water. Accordingly 0, 1, 2 or 3 displays
are lit (see table). Factory setting: 1.
1. Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
2. Setting can be found in the water
hardness table.
3. Close the door.
4. Switch on ON/OFF switch (.
The Cleaning display )* flashes.
5. Press and hold down the START
button @.
6. Rotate programme selector 8 until
the salt refill indicator ` flashes.
7. Release button.
The salt refill indicator ` flashes
and the display “Check water
supply” h are lit (= Setting 1).
To change the setting:
1. Rotate programme selector 8 until
the required setting has been
selected.
2. Press START button @.
The salt refill indicator ` goes out.
The selected setting is saved.
Water hardness table
To Next Page
Loading...
