Why won't the displays light up on my Bosch SMS6HCI01Z/36?
If no displays light up on your Bosch Hob, it could be due to a disconnected power supply. Check other electrical appliances to see if there's a power failure. Also, ensure the appliance is connected according to the circuit diagram. If these steps don't resolve the issue, it may be an electronics fault, and you should contact technical after-sales service.
How do I unlock the button lock on my Bosch Wine Cooler?
To unlock the button lock on your Bosch Wine Cooler, simply press any touch field.
What to do if there is hot cookware near the control panel of my Bosch Hob?
If there's hot cookware near the control panel of your Bosch Hob, it may cause the electronics to overheat. Remove the cookware. The fault display should disappear shortly afterwards, and you can continue to cook.
How to fix Bosch SMS6HCI01Z/36 Hob when electronics overheat and cooking zones switch off?
If the electronics in your Bosch Hob have overheated and cooking zones have switched off, it is because the electronics have overheated. Wait for them to cool down sufficiently, then touch any button on the control panel.
How to prevent damage from condensate returning to my Bosch Ventilation Hood?
Install the exhaust duct in such a way that it falls away from the appliance slightly (1° slope).
How to avoid corrosion damage to my Bosch Ventilation Hood?
To avoid damage due to corrosion, always switch on the appliance while cooking to avoid condensation.
How to prevent humidity from damaging the circuitry of my Bosch Ventilation Hood?
To prevent humidity from damaging the electronic circuitry, never clean operator controls with a wet cloth.
How to prevent poisoning from flue gases with my Bosch Ventilation Hood?
Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as a room air-dependent heat-producing appliance.
What causes surface damage to my Bosch Ventilation Hood?
Surface damage can occur if you use strong and abrasive cleaning agents. Never use these types of cleaners on your appliance.
How to prevent electric shock from moisture in my Bosch Ventilation Hood?
To prevent electric shock from penetrating moisture, clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.
To Next Page
General