Troubleshooting en
49
Fault Cause and troubleshooting
E:24 lights up. Water
is not drained.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
1. Clean the wastewater pump.
→"Clean wastewater pump", Page60
2. Secure the cover of the wastewater pump so it
clicks into position.
→"Clean wastewater pump", Page60
E:25 lights up. Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
1. Clean the wastewater pump.
→"Clean wastewater pump", Page60
2. Secure the cover of the wastewater pump so it
clicks into position.
→"Clean wastewater pump", Page60
E:27 lights up. Mains voltage is too low.
This is not a fault on the appliance.
1. Contact an electrician.
2. Have the mains voltage and electrical installation
checked by an electrician.
To Next Page
Loading...
