en Troubleshooting
58
Fault Cause and troubleshooting
Appliance does not
start.
Appliance door is not closed properly.
▶ Close the appliance door.
Programme starts
automatically.
You did not wait until programme ended.
▶
→"Terminate programme", Page40
Appliance stops dur-
ing the programme or
cuts out.
Appliance door is not closed properly.
▶ Close the appliance door.
Power and/or water supply has been interrupted.
1. Check the power supply.
2. Check the water supply.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
▶ Check whether the rear panel of the appliance is
being pressed in by a socket or hose holder that
has not been removed.
▶ Arrange the tableware so that no parts project bey-
ond the basket and prevent the appliance door
from closing properly.
Appliance door can-
not be closed.
Door lock has been activated.
▶ Close the appliance door with greater force.
Door cannot be closed due to installation method.
▶ Check whether the appliance has been installed
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Lid on the detergent
dispenser cannot be
closed.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
▶ Remove detergent residue.
Filling valves making
knocking noises.
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
▶ Can only be remedied in the domestic installation.
Knocking or rattling
noise.
Spray arm is striking tableware.
▶ Arrange tableware so that the spray arms do not
strike tableware.
With a small load the water jets directly strike against
the tub.
▶ Distribute the tableware evenly.
▶ Load the appliance with more tableware.