Keypad Display Icons & Meanings
How To Arm
To arm the whole alarm
Enter your 4 digit code then the [ON] button
If there are any zones unsealed (exept zones set to not test as programmed by your installer) when you
arm the system, or any system faults, you may be asked to press [OK] to force On or Bypass them.
Please contact BJR Security if this is re occurring.
To arm in partial mode
Enter your 4 digit code then the [PART] button
(Only zones discussed with your installer at time of installation will be armed in this mode)
How To Disarm
Enter your 4 digit code then the [OFF] button
Using The 4 Button Remote Controls (optional add on)
To use the remote, press and hold a button for approx 2 second until the red light comes on.
Arm the system (Full arm mode)
Arm the system in partial mode
Optional Output Control _________________________________________
How To Change Own PIN Code
Every user code can change their own code, however only the 'master code' (user 1) can be used to add, change or
delete codes other than their own.
If you only have 1 code, typically this will be the 'master code'
1. Enter your PIN code then press [MENU] then [1] then [1] then [0]
2. Enter your new PIN code then press [OK]
3. If prompted, re enter your new PIN code then press [OK]
4. Hold down the [MENU] button for approximately 2 seconds until you exit from the menu.
If you have the 'master code' and wish to add or change other codes, please refer to the full users guide.
To Previous Page
Loading...
Need help?
General
