What to do if a Shock Alarm is present on my Bosch ISN-SM-30 Security System?
To address a shock alarm on your Bosch Security System, try the following: * Adjust the shock settings to reduce noise. * If possible, change the detection radius to eliminate the noise. * Utilize the digital filter options to remove the noise. * Locate the source of the alarm and take actions to prevent it.
How to fix PC communication issues with the Bosch ISN-SM-30 Security System detector?
If your PC is unable to communicate with the detector of your Bosch Security System, please verify the following: 1. Ensure the correct COM port is selected (usually COM1). 2. Close any other applications that might be using the port. 3. Confirm the connection cable is securely plugged into both the PC's serial port and the detector. 4. Make sure the detector has power. 5. Check that DIP switches 1 and 2 are in the ON position to enable communication. 6. Verify a detector type has been selected and that it is the correct type. 7. Confirm you are using a compatible version of SensTool. 8. If using a USB/Serial adapter, ensure the correct driver software is installed on your PC.
What to do if there is an Integration Alarm present on my Bosch ISN-SM-30 Security System?
If an Integration Alarm is present on your Bosch Security System, consider these steps: * Check terminal 4 on the detector using a multi-meter. Refer to the Install sheet for the detector. * Ensure that the 0v applied or removed is correct for the detector configuration. * Check terminal 6 on GMXS5 with a multi-meter. Refer to the GMXS5 Install sheet for input options. * Use the digital filter options to remove the noise as required.
What to do if a Temperature Alarm is present on my Bosch Security System?
If a Temperature Alarm is present on your Bosch Security System, use SensTool to adjust the settings as needed.
General| Detection Angle | 90° |
|---|---|
| Storage Temperature | -20°C to +70°C |
| Relative Humidity | 95% (non-condensing) |
| Housing Material | ABS plastic |
| Operating Voltage | 10 VDC to 15 VDC |
To Next Page