Bosch ISN-SM-30 - 8 Senstool; Senstool GMXS7; Senstool User Mode Settings (Recommended); Setting up Senstool

7
SensTool
50
Bosch Security Systems Seismic Detectors Application Guide I-200153-1
04.2016
8 SensTool
8.1 SensTool GMXS7
Senstool is an essential part of the successful configuration of the ISN-SM-xx seismic detectors. Note
that the ISN-SM-30 does not have Senstool connectivity. It is strongly recommended that SensTool is
used for the configuration and commissioning of the ISN-SM-xx seismic detectors. Certain configura-
tion options are only available from SensTool, such as digital filters, temperature adjustment & moni-
toring, alarm contact options, test input options, remote input options, and shock sensitivity.
8.1.1 SensTool User Mode Settings (recommended)
The settings detailed below are with the digital filter set to OFF.
Construction
Impact
sensitivity
Application
Steel 1.0m
Low
Ticket machine with loud function-related noises.
Steel 1.5m
Medium
ATM, day/night vaults, safes with loud function-related noises.
Steel 2.0m
Medium
Encased safe, vault doors with function-related noises.
Concrete 2.5m
High
Vault room, element vault with some interfering influences.
Concrete 4.0m
High
Vault room, element vault with low interfering influences.
Concrete 5.0m
High
Vault room, element vault with minimal interfering influences.
LWS 1.5m
High
ATM made of plastic plating system with function-related noises.
LWS 2.0m High
Element vault made from plastic plating system with minimal
noises.
Table 8-1: Recommended SensTool user mode settings
8.2 Setting up Senstool
The set up procedure is well documented in the SensTool manual and once communications have
been established the testing and recording of the data can commence. There is support information
available as part of the software package.
F
igure 8-1: SensTool software