Need help?Do you have a question about the Bosch ICP-MAP5000-2 and is the answer not in the manual?
General| Type | Control Panel |
|---|---|
| No of areas | 2 |
| Battery Backup | Yes |
| Communication | Ethernet, PSTN, GSM |
| Supported Protocols | SIA |
| Operating Temperature | -10 to +55 °C |
| Humidity | 95% non-condensing |
Manual content overview.
System certifications and approvals.
Safety instructions for battery handling.
Important factors for system installation.
Guidance on planning the system configuration.
Visual overview of system components in enclosure.
Detailed breakdown of enclosure components and elements.
Steps to remove knockout plugs from the enclosure.
Instructions for mounting the tamper switch rail.
Procedures for securely mounting the enclosure.
Steps to verify the AC power connection.
Installing power supply unit and AC terminal block.
Instructions for installing the TAE box.
Mounting the plate for accessories inside the enclosure.
Installing the 12V converter module.
Installing the fuse plate (SIV) module.
Installing the AT 2000 communicator module.
Installing the hinged mounting plate for modules.
Procedures for mounting the main system panel.
Installing the ICP-COM-IF relay module.
Installing and connecting the wireless modem.
Information on magnetic and rod antennas.
How to connect system modules via the data bus.
Explains the internal and external data bus types.
Guidelines for external data bus topology.
Using a CAN splitter to divide the data bus.
Connecting control centers to the data bus.
Wiring and connection details for the main panel.
Steps for connecting the system's power supply.
Connecting the LSN gateway module to the system.
Optional connection options for the system.
Installing and connecting tamper switches.
Installing the enclosure lockset.
Mounting instructions for the control center.
Connecting the operating and display panel.
Mounting location and considerations.
Wiring the LED panel to the ISP-EMIL 120.
Programming guidance for the ISP-EMIL 120 module.
Final steps for connecting power to the system.
Configuring and connecting the IP interface.
Preliminary checks before system setup.
Overview of system programming using RPS software.
Steps to install the RPS for MAP software.
Performing programming compliant with standards.
Procedures for updating system software.
Verifying software versions of system modules.
Authorizing manufacturer access for software transfer.
Final steps to complete the installation process.
Defining and evaluating point types.
Configuring and managing output functions.
Setting up programmable output signals for various events.
Details on the ICP-MAP0115 power enclosure.
Installing rack mount brackets for expansion enclosure.
General guidelines for maintenance and service.
Using the installer button for system operations.
Requirements for VdS class C compliance.
Setting default values for VdS class C.
Power supply considerations for different areas.
Information on control centers and display panels.
Connecting the system to a management system.
Details on connecting a printer.
Defines different access levels for users.
Requirements for EN 50131 grade 3 compliance.
Setting default values for EN 50131 grade 3.
Peripherals certified for EN 50131 grade 3.
Arming/disarming procedures without delays.
Arming/disarming procedures with delays.
Configuring automatic bypass for arming.
Automatic arming and disarming configurations.
Configuring alarm outputs for sirens and communicators.
Connecting the system to a management system.
Details on connecting a printer.
Defines different access levels for users.
Additional functionalities of the main panel.
Requirements for SES compliance.
Setting default values for SES compliance.
Automatic arming and disarming configurations.
Managing areas with blocking time.
Defines different access levels for users.
Tamper switch surveillance for the main panel.
How the system handles alarm reporting.
To Next Page