44 en | Connections MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
Data bus connection of the control center on the external BDB
3.3 Connecting the main panel
This chapter describes the connection of the following main panels:
– MAP Main Panel (ICP-MAP5000-2)
– MAP Main Panel with IP Communicator (ICP-MAP5000-COM) including the MAP GSM
module (ITS-MAP0008).
Connection strip of the main panel
Connection Description
1 External BDB connector
2 Two programmable voltage outputs (28 V DC / 1 A)
3 Two programmable dry relay outputs (toggle switches)
4 Voltage output AUX (28 V DC / 1 A)
5 Eight supervised inputs
6 Input for panel tamper switch
External BDB connector (1)
4 Use this connection to connect additional system modules to the external BDB (refer to
Connecting the data bus, page 40 and Modules on the BDB, page 42).
To Next Page
Loading...
