72 en | Appendices MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
8 Appendices
This chapter contains information and instructions for creating programming that complies
with the requirements of a specific standard.
Notice!
Use the default setting for parameters that are not explicitly mentioned in this description. In
addition, the instructions for panel validation in the RPS for MAP programming software
must be followed.
8.1 Requirements in accordance with VdS class C
8.1.1 Selecting the default setting
4 Select VdS class C as the default property values setting.
See also
– Standard-compliant programming, page 59
8.1.2 Power supply for areas
Refer to Connecting the LSN gateway, page 46.
8.1.3 Control centers and display panel
Refer to:
– Connecting the control center, page 43
– Connecting the operating and display panel, page 54
– Programming instructions for ISP-EMIL 120, page 56
– Planning the system with IPP-MAP0005 power supply, page 7
– Planning the system with ICP-MAP0012 CAN splitter module, page 10
8.1.4 Connection to a management system
Refer to IP Interface, page 57.
8.1.5 Printer connection
Connecting the DR2020T printer is permitted only for service purposes.
8.1.6 Access levels
The standard distinguishes between four access levels (AE):
– AE 1 Access for everyone, no authorization/code required
– AE 2 Access for users, user passcode required
– AE 3 Access for installers via control center or via RPS for MAP
– AE 4 Access for manufacturers via RPS for MAP
Selecting the access level
AE 1 Access for everyone, no authorization/code required
AE 2 Access for users, user passcode required
AE 3 Access for installers via control center
1. Open control panel enclosure.
Switch to installer mode (refer to Installer button, page 67).
2. Enter installer passcode.
AE 3 Access for installers via RPS for MAP
To Next Page
Loading...
