46 en | Connections MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
Connecting the power supply
Connection Description
1 Battery circuit 2
2 Battery circuit 1
3 Connection for thermistor
4 Power connection to main panel
5 Input for tamper switch, is activated by configuration for remote operation of
the power supply on the external BDB.
6 Output for voltage supply (switched), supervised, nominal voltage 24 V DC
7 Data bus - connection A
8 Data bus - connection B
9 Output for AC fail and summary power supply trouble (optional)
10 AC connection
3.5 Connecting the LSN gateway
Notice!
When connecting an LSN component, ensure that you follow local standards and guidelines
when planning the system installation.
The following applies for VdS systems: Each area must be supplied with power
independently. The outputs AUX1 and AUX2 on the LSN gateway (for max. two areas) or the
voltage outputs of the fuse plate (SIV) (for additional areas) are available for this purpose.
To Next Page
Loading...
