MAP 5000 Connections | en 45
Bosch Sicherheitssysteme GmbH Installation manual 2016.06 | 17 | F.01U.168.332
Programmable voltage outputs (2)
4 Use these connections to control devices in certain system states (refer to Programmable
output signals, page 61).
Programmable dry relay outputs (3)
4 Use these connections to control devices such as self-powered signaling devices in
certain system states (Programmable output signals, page 61).
Voltage output AUX (4)
4 Use this connection to supply voltage to devices in the panel. The voltage can be
switched on/off in certain system states.
Supervised inputs (5)
4 Use these inputs to connect supervised conventional detectors or key switches RE = 12.1
KOhm (refer to Point types and point evaluation, page 60).
Input for panel tamper switch (6)
4 Use this input to connect the tamper switch of the panel (refer to Connecting the ICP-
MAP0050 tamper switch, page 52).
3.4 Connecting the power supply
1. Connect the supplied thermistor cable (P/N F01U074759).
2. Mount the thermistor inside the enclosure.
3. Connect the AC terminal block to the power supply.
4. Connect the power supply to the main panel using the supplied four-pin connector cable
(P/N: F01U074769).
Mounting the thermistor
To Next Page
Loading...
