EasyManuals Logo

Bosch ICP-MAP5000-2 User Manual

Bosch ICP-MAP5000-2
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
MAP 5000 Introduction | en 5
Bosch Sicherheitssysteme GmbH Installation manual 2016.06 | 17 | F.01U.168.332
1 Introduction
1.1 Short information
This manual describes the installation, wiring, initial set-up and maintenance of the MAP 5000
system.
It is applicable for the following main panels including all accessory MAP 5000 products:
MAP Main Panel (ICP-MAP5000-2)
MAP Main Panel with IP Communicator (ICP-MAP5000-COM) including the MAP GSM
module (ITS-MAP0008).
1.2 Listings and approvals
The system is designed to comply with the certifications and approvals listed here.
Region Agency Certification
Germany VdS Class C, VdS G 111040
Europe CE Conformité Européene
Europe EN EN 50131-1:2006 + A1:2009
EN 50131-3:2009
EN 50131-6:2008
EN 50136-2/SP4/DP3
EN 50131-10
Switzerland SES Association of Swiss Installers of Security Systems
Edition V3 / 01.01.2011-d
France AFNOR / CNPP
Cert.
NF&A2P Grade 3
Certificate Number 1133400003A0
According to NF324-H58
1.3 Battery handling
The battery terminals must be covered after installation in order to avoid short circuits.
Suitable terminal covers are included in the scope of delivery of the power supply.
Danger!
Electrictity
Do not short-circuit the battery in the host alarm system. A short-circuited battery can deliver
large currents that might result in serious burns or create a fire hazard.
Further information is available at http://www.boschsecurity.com/standards.
1.4 Installation considerations
When installing this system, ensure that all local and national wiring codes are met.
Only authorized service personnel is allowed to install this system.
Use only the installation material recommended by BOSCH Security Systems to ensure
error-free operation.
Follow anti-static procedures when handling system components. Ensure that you are
properly grounded to discharge any static charge before you work with system
components.
Install all components in dry, maintained interior rooms.
Install the system in a centrally located room that is near the AC Power MAINS.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch ICP-MAP5000-2 and is the answer not in the manual?

Bosch ICP-MAP5000-2 Specifications

General IconGeneral
BrandBosch
ModelICP-MAP5000-2
CategorySecurity System
LanguageEnglish

Related product manuals