Bosch ICP-MAP5000-2 - Installing the ICP-COM-IF relay module

36 en | Installation MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
Ferrite core
2.13 Installing the ICP-COM-IF relay module
The ICP-COM-IF relay module can be mounted on the hinged mounting plate or the mounting
rails of the MAP control panel enclosure.
A clearance of approx. 15mm is required on either side for subsequent wiring. The terminal
plugs can be unplugged laterally.
1. Attach the carrier plate of the ICP-COM-IF relay module in the holes provided in the
hinged mounting plate or the mounting rails.
2. Use the screw provided to secure the carrier plate to the bottom rail.