16 en | Installation MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
4 Knockout for AC wires (use when AC wires come in from the back of the
enclosure)
5 Side wall knockouts for wiring
2.2 Installing the tamper switch rail
1. Remove the tamper switch rail from the package.
2. Mount the tamper switch rail to the inner right side of the enclosure as shown in the
figure below.
3. Secure the tamper switch rail with the two supplied screws.
Do not mount the tamper switch at this time.
Mounting the tamper switch rail
To Next Page
Loading...
