Bosch SPE53C55UC - Page 43

Troubleshooting en-us
43
Issue Cause and troubleshooting
There are remov-
able streaks on
glasses, glassware
with a metallic ap-
pearance and silver-
ware.
Amount of rinse aid to be dispensed is set too
high.
▶ Set the rinse aid system to a lower setting.
→ "Setting the amount of rinse aid", Page20
No rinse aid has been added.
▶ Add rinse aid.
→ "Adding rinse aid", Page19
There is detergent residue in the final rinse. Lid of
detergent dispenser is blocked by dishware and
will not open fully.
1. Arrange dishware in the upper rack so the tab
collecting tray is not obstructed by dishware.
→ "Loading dishware", Page23
Items of dishware are blocking the dispenser
lid.
2. Do not place dishware or fragrance dispensers
in the tab collecting tray.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
▶ Only remove large remnants of food and do not
pre-rinse dishware.
Irreversible clouding
of glassware.
Glasses are not dishwasher-proof, only suitable
for dishwashers.
▶ Use dishwasher-proof glasses.
Glasses are usually only suitable for cleaning
in a dishwasher, i.e. long-term wear or long-
term changes must be expected.
▶ Avoid a lengthy steam phase (standing time af-
ter wash cycle ends).
▶ Use a program with a lower temperature.
▶ Use detergent with a glass protection compo-
nent.
Detergent residue is
present in the deter-
gent dispenser or
the tab collecting
tray.
Spray arms were blocked by dishware so deter-
gent was not rinsed out.
▶ Check that the spray arms are not blocked and
can rotate freely.
Detergent dispenser was damp when detergent
was added.
▶ Only add detergent to the detergent dispenser
when dry.
Excessive formation
of foam occurs.
Hand soap got in the rinse aid dispenser.
▶ Immediately add rinse aid to the dispenser.
→ "Adding rinse aid", Page19