English | 35
Monitoring
times were empirically tested during practical tests and
times were selected that are neither too long nor too short.
▷ If you do not want to wait for this time, you can activate
monitoring by entering the device PIN, see page 33.
You will receive a push message when the monitoring has
been successfully activated.
▷ You now have about one minute to leave the room to be
monitored.
A rising tone sequence confirms that monitoring has been
activated. After activating monitoring, the LEDs pulsate
green for 60 seconds. This indicates calibration of the
sensors and signals the remaining time to leave the room to
be monitored.
To Next Page
Loading...
