Bosch SSB1000 TL - Screens; Splash Screen (Rev 1.1.0.13425); Entering the Menu; Protected Menu Items

SSB 6720892984 (2019/02) US
Service display | 19
4.2 Screens
4.2.1 Splash screen (Rev 1.1.0.13425)
Heating System B.V.
This screen is active during power up and will remain active until
communication with the Main Control (the AL-BUS) has been established.
Standard no default start-up screen is installed, only the text “initializing”
will appear (for certain projects a ‘Settings parameter is available to select
a customized splash screen).
After communication has been established the following Status overview
appears:
10.0°C
Actual Setpoint
50.0°C
Set Actual setpoint/DHW setpoint directly via the Status overview
When CH is active, you can adjust the Actual setpoint directly on the
bottom of the Status overview.
When DHW is active, you can adjust the DHW setpoint directly on the
bottom of the Status overview.
This means that when CH is active, you cannot set the DHW setpoint
directly via the Status overview.
When DHW is active, you also cannot set the Actual setpoint (CH
setpoint) directly via the Status overview.
Press UP/DOWN to select the mode, then press ENTER/RIGHT to
conrm the mode and the Actual/DHW setpoint becomes directly settable.
Use UP/DOWN to increase/decrease the setpoint.
Press ENTER/RIGHT to conrm your alteration or press BACK/LEFT to
cancel.
A setpoint is only visible on the main screen when no error or alert is
active. In case of an active error or alert, the bottom right part of the PB
screen is used to display the error or alert text.
Disable the DHW Service (only for Storage appliance with 850MN)
It is possible to disable the DHW service by keeping pressing ENTER for
5 seconds.
The display will then show the string “Standby” on the Status overview.
The request for demand will be ignored in the following cases:
• DHW REQUEST demand
• STORAGE COLD demand
• PRE HEAT demand
• TAP FLOW demand
Press the ENTER button again for 5 seconds in order to re-enable the
DHW service.
4.2.2 Entering the menu
Enter the menu by pressing the MENU button once. The header in the
screen shows you are inside the main menu.
While scrolling through the menu you will see that the selected menu item
is shown in a white rectangle.
Menu
Heating
Sanitary Water
Information
Settings
Enter a menu item by pressing ENTER or RIGHT.
The header shows your location inside the menu, as seen in the following
image on the next page:
Heating
CH Setpoint
Climatic Compensation
If you are inside the menu (or a menu item) and want to return directly to
the Status overview press MENU/ESC.
If you want to go back one step in the menu press BACK/LEFT.
4.2.3 Protected menu items
Some menu items are protected and only accessible via a password*.
The following password screen will then appear:
Password
0 * * *
Enter the password with the following steps:
1 Use the UP/DOWN button to adjust the rst number
2 Press ENTER or RIGHT to conrm and to go to the following number.
3 Enter 0300.