52 | English
Bosch TCC78K751 | 01/2014
7. Wipe out the inside of the tray holders.
8. Clean the milk frother (procedure
described below).
9. Replace all the parts again.
Important: Drip tray for coffee
outlet (27) and coffee grounds
container (28) should be emptied
and cleaned daily to prevent
mould from developing.
If the appliance is switched off
using the button (3) (rinsing
and switching off) or it switches
off in accordance with the “Auto
off after” settings, the rinsing
process will automatically
take place. In other words the
pipework inside the appliance is
cleaned by the machine itself.
Important: If the appliance has
not been used for a prolonged
period of time (e.g. after a
vacation), clean the entire
appliance thoroughly, including
the milk system and brew-ing unit.
Cleaning the milk system
Risk of burns! The milk frother
(12) gets very hot. After use, allow
to cool down
first before
touching.
The message
Please short rinse the milk system.
Press
o
appears
– if cleaning has not been performed after
use
– if the appliance has just switched off
automatically and it was not cleaned
beforehand.
If this message appears, start with Step 2
under “Short rinse for milk system”.
Clean the milk system immediately after
use.
Short rinse for milk system:
1. In the menu for drink selection, select
Short rinse and press
o
start/stop
(10).
2. Place a cup under the milk frother (12)
and the end of the milk tube in the cup.
3. Press
o
start/stop (10). The appliance
now fills the cup automatically with
water and draws it in again through
the milk tube for rinsing. The rinse
procedure takes about 1 minute.
4. Empty the cup and clean the milk tube.
All the parts can also be put in the
dishwasher.
To Next Page
Loading...
