EasyManua.ls Logo

Bosch TCC78K751 - Page 58

Bosch TCC78K751
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56 | English
Bosch TCC78K751 | 01/2014
To start without the prompt (see
“Displaying Settings”) press and hold down
°
(9) for at least three seconds and select
Descaling program Start with
o
Press
o
start/stop (10). The display
will guide you through the programme.
Empty drip tray
Empty the drip tray (22).
Replace drip tray
Replace the drip tray.
If the milk frother is not inserted,
the following message is displayed:
Set up milk frother
Insert the milk frother (12)
Place container under milk frother
Press
o
Place a container with a capacity of
0.5 litres under the milk frother (12).
Press
o
start/stop (10).
The coffee grounds container (28)
can also be used. To avoid splut-
tering, push the coffee outlet (11)
down fully.
If the water filter is activated, the
following message is displayed:
Remove filter
Press
o
Remove the water filter and press
o
start/stop (10).
Add 0.5 l water and descaler
Press
o
Pour lukewarm water into the empty
water tank (14) up to the calc
(0.5 litre) mark and dissolve two
descaling tablets in it. Press
o
start/
stop (10). The descaling programme
now runs for about 24 minutes:
Descaling
If there is not enough descaling
fluid in the water tank, the
following message is displayed:
Not enough descaling fluid
Refill fluid Press
o
Pour lukewarm water into the empty
water tank (14) up to the calc (0.5 litre)
mark and dissolve two descaling tablets
in it. Press
o
start/stop (10). The
descaling programme will continue.
Clean and refill water tank
Press
o
Rinse the water tank and refill it with
fresh water up to the “max” mark.
Press
o
start/stop (10). The descaling
programme will now run for about
1 minute:
Descaling
Empty drip tray
Empty the drip tray.
Replace drip tray
Replace the drip tray.
Replace the filter if one is being used.
The appliance is ready for use again.
Important: Wipe down the appli-
ance using a soft, damp cloth to
immediately remove any descaler
residue. Such residue can cause
corrosion. New sponge cloths
may contain salts. Salts can cause
rust film on stainless steel and
must therefore be washed out
thoroughly before use.

Other manuals for Bosch TCC78K751

Related product manuals