To Next PageTo Next PageWhy is my Bosch TDA5028110 not heating up?
If your Bosch Iron isn't heating up, there are several possible reasons. First, ensure the temperature control isn't set to the minimum; if it is, turn it to a higher setting. Second, check that the iron is properly connected to a working power outlet by testing the outlet with another appliance. Finally, the 'secure' system might have been activated; try gently moving the iron to reconnect it.
Why does no steam come out of my Bosch TDA5028110?
If steam isn't coming out of your Bosch Iron, check these potential causes: * Ensure the steam control isn't set to the ' ' position; adjust it to an open steam position. * Verify that there's water in the tank; if not, fill it. * Make sure the temperature isn't too low; set it between '••' and 'max' and wait for the lamp to go out. * Note that the anti-drip system may be activated.
Why my Bosch TDA5028110 Iron does not heat up?
If your Bosch Iron isn't heating up, first check that the temperature control isn't set to the minimum; if it is, turn it to a higher setting. Also, if the 'auto off' indicator lamp is flashing, the 'secure' system may have been activated, putting the iron in stand-by mode. To reconnect it, gently move the iron around.
How to fix Bosch TDA5028110 Iron when steam does not come out?
If steam isn't coming out of your Bosch Iron, first ensure that the steam regulator isn't set to the '0' position; adjust it to a higher setting. Also, check that the temperature isn't too low and increase it if the fabric is compatible. It is possible that the anti-drip system is activated.
How to clean Bosch Iron if deposits come out?
If deposits are coming out through the holes in the soleplate of your Bosch Iron, it indicates that traces of lime scale are coming out of the steam chamber. You should carry out a cleaning cycle referring to the “Calc’nClean” section.
What to do if water drips out of my Bosch TDA5028110?
If water is dripping from the soleplate of your Bosch Iron along with steam, consider these factors: * The temperature control might be set too low; increase it if compatible with the fabric. * The steam control could be too high for the low temperature setting; reduce the steam control. * You may be pressing the shot of steam button too frequently; wait 5 seconds between each press. * You might be using pure distilled water or have added fragrant water to the tank; mix distilled water with tap water as directed and avoid adding other products unless recommended by Bosch.
Why does the spray not work on my Bosch TDA5028110?
If the spray function on your Bosch Iron isn't working, there could be two reasons. First, check if there is water in the tank and fill it if necessary. Second, the mechanism might be obstructed.
Why is no steam coming out of my Bosch TDA5028110?
If steam isn't coming out of your Bosch Iron, there could be several reasons. First, check that the steam control isn't set to the ' ' position. Second, make sure there is enough water in the tank; if not, fill it. The temperature may also be too low, or the anti-drip system may be activated.
What to do if water drips out of the soleplate of my Bosch TDA5028110 Iron?
Water dripping from the soleplate of your Bosch Iron along with steam can occur for several reasons: the temperature control setting might be too low, the steam control might be set too high in conjunction with a low temperature, you may be pressing the shot of steam button repeatedly without waiting 5 seconds between each press, or pure distilled water (or other products like fragrant water) may have been added to the tank.
Why are deposits coming out of my Bosch TDA5028110 Iron?
If deposits are coming out through the holes in the soleplate of your Bosch Iron, it indicates that traces of lime scale are coming out of the steam chamber. Perform a cleaning cycle.
General| Type | Steam Iron |
|---|---|
| Power | 2400 W |
| Soleplate Material | Ceramic |
| Steam Boost | 200 g/min |
| Cord Length | 2.5 m |
| Vertical Steam | Yes |
| Anti-drip System | Yes |
| Calc Clean Function | Yes |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Auto Shut-off | Yes |
| Anti-Calc System | Yes |
| Self-Cleaning | Yes |
