Bosch TES50159 - Frost Protection; Accessories

Robert Bosch Hausgeräte GmbH
18 en
LED
h lights up.
● Place a container with a capacity of at
least 0.5 litres under the milk frother
outlet (6).
● Pull out the milk frother (6) to open it.
The service programme will now run for
approximately 12 minutes.
LED D lights up.
● Rinse the water tank (16) and rell it with
fresh water up to the max mark.
● Press the start button (10).
The service programme will now run for
approximately 30 seconds and rinse the
appliance.
LED h lights up.
● Push the milk frother (6) in to close it.
The service programme will now run for
approximately 8 minutes.
LED H lights up.
● Empty the drip tray (8) and reinsert it.
If you are using a lter, reinsert it now.
The appliance has been cleaned, descaled
and is ready for use again.
Frost protection
¡
To avoid damage caused by frost
during transport and storage, the ap-
pliance must be completely emptied
rst.
Information: The appliance must be ready
for use and the water tank (16) lled.
1. Place a large container under the milk
frother outlet (6).
2. Press the steam button (11).
LED
h ashes and the appliance now
heats up for approximately 20 seconds.
3. If LED h lights up, open the milk frother
(6) by pulling it out and release steam
for about 15 seconds.
4. Press the power on/off switch O / I (9) to
switch off the appliance.
5. Empty the water tank (16) and the drip
tray (8).
Accessories
The following accessories are available
from retailers or from customer service:
Order number Retailer Customer
service
Cleaning
tablets
TCZ6001 310575
Descaling
tablets
TCZ6002 310967
Water lter TCZ7003 467873
Grease (tube) – 311368
TES501_Heft1_RW.indb 18 14.09.2011 16:10:31