Bosch TRZ 12-2 - Entering the heating programme; Entering the holiday programme

6 720 641 683 (2009/09)
6 | Operation en
4.3.2 Entering the heating
programme (groups
P1...P6)
Up to 6 groups can be programmed,
each with a heating or economy
mode starting time and an allocated
temperature (for factory defaults
for groups
P1..P6 refer to table in
Appendix).
In the default setting, groups P1 and
P2 are active.
Activating/deactivating groups
B Press the Prog button (5) repeat-
edly until the desired group
appears.
B Press the Set button (17) so that
the group number (1...6) stops
flashing (= ON) / starts flashing
(= OFF).
B If desired: select another group.
B Press the Prog button (5) repeat-
edly until SEt appears.
B Press the Set button (17) to
store the active group settings.
Changing the basic setting
B Press the Prog button (5)
repeatedly until the desired
group appears.
B Press and hold the Day button
(4) and set the days of the week
(1...7, 1-5, 6-7 or 1-7) by press-
ing the / buttons.
B Press and hold the Hour button
(3) or the Minute button (2) and
use the / buttons to set
the start time for heating/econ-
omy mode.
B Set the temperature using the
/ buttons.
B Press the Prog button (5)
repeatedly until SEt appears.
B Press the Set button (17) to
store the settings.
4.3.3 Entering the holiday
programme
B Press the Holiday button, ,
(18).
The hour display will start flash-
ing.
B Press and hold the Day button
(4) and set the number of days
until the holiday programme is
to start by pressing the /
buttons (max. 99 days – the pro-
gramme starts at midnight, so
you should not include today).
The minute display will start
flashing.
Avoid time overlaps.