Bosch UML-323-90 - User Manual

Other manuals for Bosch UML-323-90

Installation Manual68 pages

Questions and Answers

J
Jonathan JacksonAug 10, 2025
What to do if the error message 'Out of Range' is displayed on my Bosch UML-323-90?
- S
  Sierra WheelerAug 10, 2025
  If you see the 'Out of Range' error message on your Bosch Monitor, it means your PC is using a resolution or timing mode that the monitor doesn't support. To fix this, change your PC's timing mode to one of the following valid combinations: 640 x 480 (60/72/75Hz), 720 x 400 (70Hz), 800 x 600 (60/75Hz), 1024 x 768 (60/75Hz), 1280 x 768 (60Hz), 1280 x 960 (60Hz), 1280 x 1024 (60Hz), 1366 x 768 (60Hz), 1600 x 1200 (60Hz), or 1920 x 1080 (60Hz).
D
Diana RuizAug 16, 2025
How to troubleshoot a Bosch UML-323-90 Monitor with no image on the screen?
- D
  David AndersonAug 16, 2025
  If no image is displayed on your Bosch Monitor, try the following: * Ensure the monitor's power cord is securely plugged into the wall outlet or a grounded extension cable. * Confirm the power switch is in the ON position and the LED is lit. * Check that the Brightness and Contrast settings aren't set to the minimum.
T
Theresa DoyleAug 22, 2025
Why are the colors on my Bosch UML-323-90 Monitor incorrect, and how can I fix it?
- C
  christine86Aug 22, 2025
  If the colors on your Bosch Monitor appear incorrect, try these solutions: 1. Select a color temperature in the Color Tone menu. 2. Use the Reset function to revert to the default settings.
H
Heather JacksonAug 28, 2025
How to fix the display image if it's not centered on my Bosch Monitor?
- A
  Ashley PaceAug 28, 2025
  To correct a display image that is not centered, or is too small or too large on your Bosch Monitor in PC mode: * Press the down arrow key to activate the Auto Adjust function. * Adjust the Frequency and Phase in the PC OSD submenu.
B
bruce39Sep 3, 2025
What to do if there is vertical or horizontal noise on my Bosch Monitor?
- A
  abigail93Sep 4, 2025
  To address vertical or horizontal noise in the picture on your Bosch Monitor: * Press the down arrow key to activate the Auto Adjust function. * Adjust the Frequency and Phase in the PC OSD submenu.