To Next PageTo Next Page
Need help?Do you have a question about the Bosch UniversalCut 18V-65 and is the answer not in the manual?
General| Battery Voltage | 18 V |
|---|---|
| Max. Cutting Depth in Wood | 65 mm |
| Max. Cutting Depth in Plastic | 65 mm |
| Cutting Depth (Metal) | 8 mm |
| Saw Blade Bore Diameter | 20 mm |
| Cutting Depth (Steel) | 8 mm |
| Battery Type | Li-ion |
| Battery Compatibility | Bosch 18V batteries |
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Guidelines for using and caring for the power tool.
Guidelines for using and caring for the battery tool.
Information on servicing and maintaining the power tool.
Specific safety advice for using the all-purpose saw, including handling and workpiece support.
The power tool is intended for domestic use only. It is intended for cutting branches, slats, etc.
The numbering of the product features refers to the diagram of the power tool on the graphics page.
Specifications table with Article number, Rated voltage, No-load speed, etc.
Noise emission values determined according to EN 62841-2-11.
Wear hearing protection! Vibration total values aht (triax vector sum) and uncertainty K determined according to EN 62841-2-11.
Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery.
Push the charged battery into the battery holder until it clicks into place.
Press the battery release button and pull the battery out. Do not use force.
Indicates the remaining battery capacity or an overload when the power tool is switched on.
Only use saw blades that are suitable for the material you are going to cut.
Use only clean saw blades. Make sure the saw blade receptacle is free of chips and sawdust.
Open the locking lever to open the cover of the saw blade receptacle. Remove the saw blade.
Ensure good ventilation and wear a P2 filter-class respirator when handling dusty materials.
Switching on/off the power tool.
You can control the speed of the power tool by how hard you press the on/off switch.
Electronics switch off the tool if overloaded or battery temperature is exceeded.
Switch off immediately if the saw blade becomes blocked. Use sturdy support for small workpieces.
Remove battery before work. Keep tool and ventilation slots clean.
Sort power tools, batteries, accessories and packaging for environmental-friendly recycling.
Declaration for the product according to EU directives and standards.
Declaration for the product according to EU directives and standards.
Declaration for the product according to EU directives and standards.
Declaration for the product according to EU directives and standards.
Declaration for the product according to UK regulations and standards.
