Troubleshooting
TO AVOID RISK OF
ELECTRICAL SHOCK!
Repairs or replacement of parts
shall be carried out by qualified
technicians or licensed
electricians only_
Before calling Customer Service, check
whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
1. Set program selector to "Off".
2. Turn off the circuit breaker.
3. Pull the main plug out of the
socket.
4. Call customer service
(see page 32).
Troubleshooting items listed below may
not be covered by warranty service
Please rule out any of these issues
before calling for service.
Problem
Dryerdoesnotstart,
"Start!Pause"indicatorlightdoesnot
illuminate,
Cyclehasbeeninterrupted.A warning
signalis emittedandthe displayshows
"CLn",
Cyclehasbeeninterrupted.A warning
signalis emittedandthe displayshows
"E:12",
Degreeof dryinghasnot beenreached
or thedryingtime istoo long,
Displaymayindicate"E:03",
Drumlightdoesnotfunction,
Possiblecause
Mainplugnot insertedat allor notinsertedcorrectly,
A fuseorcircuitbreakerhastripped,
"Start/Pause"buttonnotpressed,
Noprogramselected,
Doornot closed,
Ambienttemperaturebelow41°F (5°C,)
Lintfilter dirty,
Exhaustairduct is blockedortoolong,
Faultin programsequenceor malfunction,
Theroom/cabinetisnot adequatelyventilated,
Moisturesensordirty,
Exhaustair ductis blockedor istoo long,
Lintfilter dirty,
Laundrywastoo wet,
Unsuitableprogramselected,
Maximumdryingtime wasexceeded,
Motorlimittemperaturewasexceeded,
Degreeof drynessnotcorrectlyset
Noprogramselected,
Lightbulbdefective,lightbulbburnedout,
Nopowersupply,
Lightbulbis loose,
Remedialaction
Insertmainplugcorrectly,
Replacefuseor resetcircuitbreaker,
Press"Start/Pause"button,
Selectprogram,
Closedoor,
Increaseroomtemperature,
Cleanthe lintfilter asdescribedonpage27,
Switchthe dryeroff/switchonagain,Ifthis doesnot
clearthe errorcode,callCustomerService(pg,32),
Cleanexhaustair duct,Reduceexhaustair ductto
maximumlengthasdescribedon page18,
Switchthe dryeroff/switchon again,
Switchoff dryer,leavetocooldownfor 30 min,
switchon again,
Restartprogram,
Provideanadequatesupplyof freshair,
Switchoff/switchonagain,
Cleanmoisturesensoras describedon page29,
Switchthe dryeroff/switchon again,
Cleanexhaustair duct,Reduceexhaustair ductto
maximumlengthasdescribedon page18,
Switchthe dryeroff/switchon again,
Cleanfilter as describedonpage27,
Switchthe dryeroff/switchon again,
Spinlaundryat higherspeedinthe washing
machine,Switchthe dryeroff/switchonagain,
Selectprogramwithaid of the programselection
table(seepage22),Switchthedryeroff/switchon
again,
Cleanlintfilter (seepage27),
Checkexhaustair duct,
Spinlaundryat a higherspeedin yourwasher,
Switchoff dryer,leavetocooldownfor 30 min,
Switchon again,Startprogram,
800 Series,Changesettingsfor degreeof dryness,
seepage25
Selectprogram,
Replaceburnedout bulbandreinstallthe coveras
directedon page29,
Checkpowersupply,
Removethe bulbcoverandif bulbis loose,tighten
bulb,Reinstallthe coveras directedon page29,
3O
To Next Page
Loading...
