Operating the appliance en
27
Prewash
(T, Prewash)
Setting depending on the model
For heavily soiled laundry.
There will be a prewash cycle at a low
temperature before the main wash
cycle.
Note: Pour detergent into compartment
I for the prewash cycle and into
compartment II for the main wash cycle.
1 Operating the
appliance
Operating the appliance
Preparing the washing
machine
Notes
■ The washing machine must be
correctly installed and connected.
~ "Positioning and connecting"
on page 12
■ Before washing for the first time, run
a wash cycle without laundry.
~ "Before washing for the first
time" on page 17
1. Connect the mains plug.
2. Turn on the water tap.
3. Open the door.
4. Check that the drum is completely
drained. Drain if necessary.
Switching on the appliance/
selecting a programme
Note: If you have activated the
childproof lock, you must first deactivate
it before you can set a programme.
~ "Childproof lock" on page 30
Use the programme selector to select
the required programme. The
programme selector can be rotated in
either direction.
The appliance is switched on.
The programme default settings for the
selected programme appear in the
display panel:
■ Temperature,
■ Spin speed,
■ The maximum load and the duration
of the programme (alternately)
Changing the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
~ "Programme default settings"
on page 25
Overview of programmes ~
Supplementary sheet for the operating
and installation instructions.
Selecting additional
programme settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
To Next Page
Loading...
