Bosch WAX32E90ME - Basic Operation; Switching on the Appliance; Setting a Programme; Adjusting the Programme Settings

operation en
35
operation
13 Basic operation
operation
13.1 Switching on the appli-
ance
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page12
▶ Press .
The switch-on process takes a few
seconds.
a An audible function test is carried
out.
Note:The lighting for the drum goes
out automatically.
13.2 Setting a programme
1. Turn the programme selector and
set the required programme.
→"Programmes", Page29
2. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page35
Setting additional programmes
1. Set the Additional Programs
programme.
2. Press to call up the sub-menu.
3. Set a programme.
→"Setting a programme",
Page35
4. Press Main menu to call up the
main menu.
5. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page35
6. Start the programme.
→"Starting the programme",
Page36
13.3 Adjusting the pro-
gramme settings
Requirement:A programme has
been set.
→"Setting a programme", Page35
▶ Adjust the programme settings.
→"Buttons", Page26
Observe the information about op-
erating logic →Page20.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
Adjusting additional programme
settings
1. Press Options to call up addi-
tional programme settings.
2. Select the programme settings.
3. Press Options to call up the
main menu.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
1. Set the ⁠Memory programme.
2. Press to call up the sub-menu.
3. Select a programme.
→"Operating logic", Page20
4. Press Main menu to call up the
main menu.
5. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page35
a The programme is saved.