EasyManua.ls Logo

Bosch WAX32E90ME - Home Connect

Bosch WAX32E90ME
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HomeConnect en
39
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→"Cleaning the detergent drawer",
Page44
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →Page39.
Requirement:The display shows a
notification to fill the dispenser.
→"Display", Page25
1. Pull out the detergent drawer.
2. Open the dispenser cover.
3. Pour liquid detergent and fabric
softener into the relevant dis-
pensers.
→"Detergent drawer", Page18
Do not exceed the marking for the
maximum fill level when filling.
4. Close the dispenser cover.
Note:To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5. If required, pour washing aid into
the compartment for manual dos-
ing.
→"Adding detergent and care
product", Page36
6. Push in the detergent drawer.
7. Adjust the basic dosage
→Page39.
15.3 Dispenser contents
Notes
¡ If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡ If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
You can change dispenser contents
in the basic settings.
→"Changing the basic settings",
Page43
15.4 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
You can change the basic dosage for
the dispenser in the basic settings.
→"Changing the basic settings",
Page43
HomeConnect
16 HomeConnect
HomeConnect
This appliance is network-capable.
Connecting your appliance to a mo-
bile device lets you control its func-

Table of Contents

Related product manuals