Troubleshooting en
43
Fault Cause and troubleshooting
"E:30 / -80" ▶ Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→"Cleaning the drain pump", Page39.
"H:32" The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶ Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
"E:30 / -10" and/or The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶ Clean the water inflow filter.
The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.
"E:35 / -10" There is water in the base trough.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
The appliance is leaking.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the washing programme", Page33
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page26