en Troubleshooting
44
Fault Cause and troubleshooting
Detergent dosage is too high.
▶ Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
"H:95" lights up altern-
ately with End.
The water pressure is low.
▶ See
→"E:30 / -10 and/or ", Page43
All other error codes. Malfunction
1. Switch the appliance off and then on again.
2. If the message appears again, disconnect the appli-
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
3. If the message appears again, call the after-sales
service. Please specify the exact error message
when calling.
→"Customer Service", Page53
The drying time is too
long.
The ambient temperature is greater than 30 °C.
▶ Ensure that the ambient temperature is below 30
°C.
Insufficient air circulation at the appliance's installation
location.
▶ Ventilate the appliance's installation location.
Fluff has accumulated in the drum.
▶ Run the Drum Clean programme without any laun-
dry or detergent.
Creasing. The load is too large.
The laundry lies in the drum for too long after drying.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
Unsuitable programme for the type of fabric.
▶ Set the suitable programme for the type of fabric.
Easy-Care fabrics are dried for too long.
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
To Next Page
Loading...
