Bosch WNA13400ES - Filter in the Water Supply Is Blocked; The Drain Hose at the Siphon Is Blocked

Cleaning and maintenance en
45
The drain hose at the siphon
is blocked
1. Turn the programme selector to Û
(Off). Pull out the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3. Clean the drain hose and siphon
connecting piece.
4. Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
1. Turn off the water tap.
2. Select any programme (except à
(Rinse), 0 (Spin), [ (Drain)
programmes).
3. Select the A Inicio/Pausa + Carga
(Start/Reload) button. Allow the
programme to run for approx. 40
seconds.
4. Turn the programme selector to Û
(Off).
5. Pull out the mains plug.
Clean the filters:
1. Disconnect the hose from the rear of
the appliance.
2. Use pliers to remove the filter.
3. Clean the filter with a small brush.
4. Connect the hose and check for
leaks.