Bosch WNA144V9GB - Troubleshooting Common Issues; Appliance Not Working and Door Issues

en Troubleshooting
42
Fault Cause and troubleshooting
The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.
Water level measurement system is defective.
▶ Call the after-sales service.
→"Customer Service", Page51
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the washing programme", Page33
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page26
flashes. Door is not closed.
1. Close the door.
2. Press ⁠Start/ Reload to start the programme.
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press ⁠Start/ Reload to start the programme.
"Hot" and the drum ro-
tates.
Cooling process active.
1. Not a fault.
2. Do not change the programme during the cooling
process.
Note:The cooling process takes up to 10 minutes.
You can continue to operate the appliance.
Drum cleaning is required.
▶
→"Cleaning the drum", Page36
"H:95" lights up altern-
ately with End.
The water pressure is low.
▶ See
→" ", Page42
All other error codes. Malfunction
▶ Call the after-sales service.
→"Customer Service", Page51
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.