Bosch WQG233CBSN User Manual

Troubleshooting en
43
Fault Cause and troubleshooting
Condensation in the
condensation tank
even though the water
drain hose is connec-
ted.
The appliance uses condensation for the automatic
self-cleaning.
▶
Not a fault – no action required.
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→"Connecting the water drain hose", Page14
The programme does
not start.
Childproof lock is activated.
▶
→"Deactivating the childproof lock", Page34
You have not pressed ⁠ Start/ Reload.
▶
Press ⁠ Start/ Reload.
No programme set.
1.
→"Setting a programme", Page29.
2.
→"Starting the programme", Page30.
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Pumping noise. Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise. Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
The base unit's filter is soiled.
▶
→"Cleaning the filter system on the base unit",
Page32
Fluff filter is soiled.
▶
→"Cleaning the fluff filter", Page30
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
Appliance air inlet is blocked.
▶
Ensure that the air inlet on the appliance is kept
clear.
Heat exchanger is soiled.

Bosch WQG233CBSN Specifications

General

Brand	Bosch
Model	WQG233CBSN
Category	Dryer
Language	English