Bosch WQG233CBSN User Manual

en Troubleshooting
44
Fault Cause and troubleshooting
The drying time is too
long.
1.
→"Opening the base unit", Page36.
2. Clean the heat exchanger.
→"Cleaning the base unit", Page37
3.
→"Closing the base unit", Page39.
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
Aligning the appliance
The seal for the heat exchanger cover is dirty.
▶
Clean the seal for the heat exchanger cover.
→"Cleaning the filter system on the base unit",
Page32
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→"Connecting the water drain hose", Page14
The lever for the heat exchanger cover is not closed
correctly.
▶
Ensure that the lever for the heat exchanger cover
is closed correctly.
→"Closing the base unit", Page39
The water tank for the crease-removal function is
empty.
▶
→"Filling the water tank", Page35.
Water overflows when
filling the water tank.
The water tank has been filled.
Note:The overflowing water is harmless.
▶
Do not pour any more water into the water tank.
The water tank filter is soiled.
▶
→"Cleaning the water tank filter", Page39.
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→"Programmes", Page26
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
▶
Observe the maximum load capacity of the
→"Programmes", Page26.
After the end of the programme, warm laundry feels
damper than it actually is.
1. Remove the laundry from the drum as soon as the
drying programme has finished.

Bosch WQG233CBSN Specifications

General

Brand	Bosch
Model	WQG233CBSN
Category	Dryer
Language	English