EasyManua.ls Logo

Bosch WTR85V92ES - Page 39

Bosch WTR85V92ES
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting en
39
Fault Cause and troubleshooting
The programme does
not start.
Childproof lock is activated.
→"Deactivating the childproof lock", Page31
Inicio/Pausa +Carga has not been pressed.
Press Inicio/Pausa +Carga .
No programme set.
1.
→"Setting a programme", Page26.
2.
→"Starting the programme", Page26.
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
Pumping noise. Condensation pump active.
Not a fault – normal operating noise.
Buzzing noise. Compressor ventilation active.
Not a fault – normal operating noise.
The drying time is too
long.
The base unit's filter is soiled.
→"Cleaning the filter system on the base unit",
Page29
Fluff filter is soiled.
→"Cleaning the fluff filter", Page27
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
°C.
The ambient temperature is lower than 15 °C.
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
is kept clear.
Heat exchanger is soiled.
1. Opening the base unit.
→"Opening the base unit", Page33.
2. Cleaning the heat exchanger.
→"Cleaning the base unit", Page34.
3. Closing the base unit.
→"Closing the base unit", Page35.

Table of Contents

Related product manuals