Bosch WTR85V92ES - Page 40

en Troubleshooting
40
Fault Cause and troubleshooting
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
→"Aligning the appliance", Page14
The seal for the heat exchanger cover is dirty.
▶ Clean the seal for the heat exchanger cover.
→"Cleaning the filter system on the base unit",
Page29
Water drain hose is not connected correctly.
▶ Ensure that the water drain hose is connected cor-
rectly.
The lever for the heat exchanger cover is not closed
correctly.
▶ Ensure that the lever for the heat exchanger cover
is closed correctly.
→"Closing the base unit", Page35
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶ Set a timed programme for the subsequent drying.
→"Programmes", Page22
There has been a power cut.
▶ Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
▶ Observe the maximum load capacity of the
→"Programmes", Page22.
After the end of the programme, warm laundry feels
damper than it actually is.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
Unsuitable dryness level set.
▶
→"Changing the dryness level", Page21.
Drying target not adjusted.
▶
→"Adjusting the dryness level", Page21.
Load too small.
▶ Set a timed programme for the subsequent drying.
→"Programmes", Page22
Moisture sensor dirty.
▶
→"Cleaning the moisture sensor", Page35.
The drying process is interrupted and the condensa-
tion tank has been filled.
1.
→"Emptying the condensation container", Page30.