EasyManuals Logo

Bosch WTVC SERIES User Manual

Bosch WTVC SERIES
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
S
The display
shows 0:00.
Fault ce or Turn of for 30
again.
tart/Pause
indicator light
doesn’t
illuminate.
Anti
Crease/end
indicator
lights.
in program sequen
malfunction.
f dryer, leave to cool
min. and then turn on
Restart program.
Moisture sensor dirty.
ure sensor, then turn
on again.
Clean moist
dryer off and
Exhaust air duct is blocked or
too long.
Clean exhaust air duct or shorten
it below maximum length allowed.
Turn dryer off and on again.
Filter dirty.
Clean filter and then turn dryer off
and on again
Laundry was too wet.
ry at higher speed in
Spin laund
the washing machine. Turn dryer
off and on again
Unsuitable program selected.
Select suitable program and then
turn dryer off and on again
Maximum drying time ust air duct.
exceeded.
Clean filter and exha
Spin laundry at a higher speed in
your washer (to remove more
water).
Motor limit temperature was l for 30
dryer off and
on again.
exceeded.
Turn off dryer, leave to coo
min. and then turn
Degree of
drying has not
been reached
or the drying
time is too
long.
ss not set gree of
Display may
indicate E:03.
Degree of dryne
correctly.
Change settings for de
dryness.
5.6 Maintenance
5.6.1 Cleaning lint filter
The lint filter should be cleaned after each use. The Filter light comes
on after each cycle and when the door is open (while the dryer is
running) to remind customers to clean the filter. An E:01 error code
occurs when dryer runs too hot due to clogged lint filter or exhaust
vent duct. When E:01 error code occurs:
1. Immediately stop dryer by rotating cycle selector knob to Off
position, then open door.
2. Remove and clean filter.
3. Replace filter and let dryer cool down.
4. Close door, then rotate cycle selector knob to desired cycle and
press Start/Pause button to restart dryer.
If the Filter light won’t turn off, clean the lint
filter (by hand) with dish soap and water.
The lint filter is very fine and can be
clogged over time when fabric softener or
softener sheets are used.
702_58300000121945_ara_en_a Page 28 of 33

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch WTVC SERIES and is the answer not in the manual?

Bosch WTVC SERIES Specifications

General IconGeneral
BrandBosch
ModelWTVC SERIES
CategoryDryer
LanguageEnglish

Related product manuals