Failure Code fo
LED->
rt ne test program
g damp dry
he li
dryin regular dry extra dry lint filter
NTC in th
channel
e exha
E:17 X
ust
NTC above the
heater
E:18 X
Overheating
E:11 und E:12 X
Conductance
error(*)
X
6.1 Overheating fault codes
If burner or lint screen NTC’s detect overheating (e.g. from clogged
E:01 fault code will appear during drying. Running
mer test program (6.0) a ecking fault codes can
1. E:1 vel 1. Burner temperature rose
r n 5 nds once.
2. E:12 ati luffing) level 2. Burner temperature rose
or an 5ºC in econds 25 times.
3. 15 Burner fa re. Burner temperature rose more than
5º or lint scre temperature rose more than 85ºC. Motor
d ner shut o
vent ducts), an
custo service nd ch
show any of the following codes:
1 – Overheating (fluffing) le
e thanmo 8ºC i seco
– Overhe ng (f
m e th 5 s
E: – ilu
11 C en
an bur ff.
Notes:
• on’ set odes are
to tically clea d after 8 dr
lt des “must , turn dry
c sively.
• s lve is con ntri r
runs only when motor is running. When motor shuts off, burner
shuts off.
D t re control after fault codes occurred. Fault c
au ma re ying cycles without failures. If
fau co ” be cleared er on and off 8 times
suc es
Ga va nected to motor ce fugal switch, so burne
702_58300000121945_ara_en_a Page 32 of 33
To Next Page
Loading...
Need help?
General