Tips on saving energy | 33
6 720 644 144 (2010/09)
Thermostat
Fully open the thermostat to ensure that the required room
temperature is reached in all cases. Only after the required
temperature has been reached and maintained for an extended
period of time should you change the setting for the heating curve
or the room temperature on the controller.
Underfloor heating
Do not set the heating-up temperature higher than the maximum
level recommended by the manufacturer.
Ventilating
Do not keep windows slightly open for ventilation purposes. This
would continuously cool down the room without significantly
improving the air in the room. It is better to ventilate fully for a
short time (with completely open windows).
Turn off the thermostat when ventilating.
Hot water
Always set the hot water temperature to as low as possible.
A lower setting on the thermostat means a higher rate of energy
savings.
Furthermore, higher hot water temperatures result in increased
limescale deposits and thereby impair the function of the
appliance (e.g. longer heating-up times or lower output).
Circulation pump
If there is a circulation pump for hot water, use a timer programme
to control its operation according to the specific requirements
(e.g. morning, afternoon, evening).
To Next Page
Loading...
