Need help?Do you have a question about the Bose 601 Series II and is the answer not in the manual?
General| Brand | Bose |
|---|---|
| Model | 601 Series II |
| Category | Speaker System |
| Language | English |
Place Part 1 on the left and Part 2 on the right side of the listening room.
Set speakers directly against the wall or up to 12 inches away for bass reproduction.
Position speakers at least 18 inches from side walls, ideally 2-5 feet.
Space speakers 6-12 feet apart for best stereo effects in average rooms.
Do not block top grilles; avoid placing objects over 4 inches in diameter on top.
Unplug amplifier, verify speaker placement, and strip wire ends.
Use '+' and '-' terminals; ignore the '*' terminal.
Connect '-' to COM/NEG/- and '+' to POS/+ terminals on amplifier's left channel.
Repeat connection steps for Part 2 speaker and amplifier's right channel.
Ensure no loose wire strands are bridged to prevent short circuits.
Set system to MONO, position speakers closely, and play bass notes.
Reverse speaker connections if sound is not localized or bass is lacking.
Use hard surfaces and avoid sound-absorbent furnishings near speakers.
Add furnishings like carpets or drapes to reduce shrillness in bare rooms.
Move speakers away from corners and walls to reduce heavy, booming bass.
Use tone controls to adjust frequency balance for room acoustics.
Determine if issues stem from speakers or other system components.
Swap speaker connections to amplifier channels to isolate faulty units.
Contact authorized dealer if problems persist after troubleshooting.
To Next Page