Bose AMM112 - Page 10

10
DISASSEMBLY PROCEDURE
Figure 9. Woofer Cable Harnesses Removal
2.6 Remove the 2 screws securing the Wave
guide as indicated in Figure 7.
2.7 Lift out the Waveguide from the enclosure.
2.8. Remove the 8 screws securing the Woof-
er as indicated in Figure 8.
Re-assembly Note: The install torques of
Woofer is around 20 +/-1 kgf*cm.
2.9 Detach the 4 Cable harnesses from the
Woofer by pressing the white fastener as
indicated in Figure 9.
Note: Be careful When removing the Woofer
because it is very heavy.
Re-assembly Note:
The waveguide mounting holes should be top/
bottom as the red arrows indicated in Figure
10.
Note: Screw the Woofer on the at surface.
Figure 7 Waveguide Screws Removal 2
Figure 8. Woofer Screws Removal
Figure 10. Waveguide Mounting Holes