Need help?Do you have a question about the Bose AmPlus 100 and is the answer not in the manual?
General| Manufacturer | Bose |
|---|---|
| Model | AmPlus 100 |
| Frequency Response | 20Hz - 20kHz |
| Type | Amplifier |
| Signal-to-Noise Ratio | 90dB |
Introduction to the Bose AmPlus 100 amplifier and related products.
Details amplifier power output for stereo, bridged mono, and various load configurations.
Specifies the required input signal level for full power output.
Lists available input and output connection options and modes.
States the impedance for balanced and unbalanced input connections.
Specifies the impedance of the amplifier's line output.
Details the distortion levels for the line output signal.
Outlines the frequency response across different output types and conditions.
Specifies Total Harmonic Distortion levels at rated power output.
Reports hum and noise figures for line and power amplifier outputs.
Mentions the location and purpose of the power status LED.
Lists all available controls on the amplifier for operation and adjustment.
Details the maximum power draw at specified AC voltages.
Specifies the acceptable ambient temperature range for operation.
Highlights key functionalities like remote volume, protection circuits, and approvals.
Lists optional accessory cards for expanded system functionality.
Describes the type of connectors used for audio and power connections.
States the physical weight of the Bose AmPlus 100 amplifier.
Lists recommended associated equipment for the amplifier.
Overview of the 100W, 2-channel amplifier for commercial applications.
Details desk and rack mount dimensions and physical characteristics.
Describes amplifier components, input options, and rear panel connections.
Refers to installer's guide for detailed system design and installation.
Details the 5-year transferable limited warranty coverage.
Specifies power delivery in stereo and bridged mono modes with distortion limits.
States the minimum signal-to-noise ratio requirement.
Details the frequency response for 4-ohm and 70V/100V outputs.
Describes front/rear panel controls and quick connect terminal blocks.
Provides precise physical dimensions and weight of the amplifier unit.
Specifies the material and finish of the amplifier enclosure.
Confirms compliance with regulatory standards for amplifiers.
To Next Page
