8
DISASSEMBLY PROCEDURE
1. Grille Removal
1.1 On the Enclosure of the unit, remove the 6
M6 screws (both sides) securing the Grille as
indicated in Figure 3.
Re-assembly Note:
The install torques of the Grille is around 20
+/-1 kgf*cm.
2. Woofer Removal
2.1 Perform step 1.
2.2. Remove the 8 screws securing the Woof-
er as indicated in Figure 4.
Re-assembly Note: The install torques of the
Woofer is around 20 +/-1 kgf*cm.
2.3 Detach the 2 Cable harnesses from the
Woofer by pressing the white fastener as
indicated in Figure 5.
Note: Be careful When removing the Woofer
because it is very heavy.
Figure 3. Grille Screws Removal
Figure 4. Grille Screws Removal
Figure 5. Woofer Cable Harnesses Removal
To Next Page
Loading...
